How to connect my Moku:Lab to a Windows PC through direct Ethernet cable
Written by Paul Cracknell
Updated at March 25th, 2021
-
Moku:Go
Moku:Go General Moku:Go Arbitrary Waveform Generator Moku:Go Data Logger Moku:Go Digital Filter Box Moku:Go FIR Filter Builder Moku:Go Frequency Response Analyzer Moku:Go Logic Analyzer & Pattern Generator Moku:Go Oscilloscope & Voltmeter Moku:Go PID Controller Moku:Go Spectrum Analyzer Moku:Go Waveform Generator Moku:Go Power Supplies Moku:Go Lock-in Amplifier Moku:Go Time & Frequency Analyzer Moku:Go Laser Lock Box Moku:Go Phasemeter
-
Moku:Lab
Moku:Lab General Moku:Lab Arbitrary Waveform Generator Moku:Lab Data Logger Moku:Lab Digital Filter Box Moku:Lab FIR Filter Builder Moku:Lab Frequency Response Analyzer Moku:Lab Laser Lock Box Moku:Lab Lock-in Amplifier Moku:Lab Oscilloscope Moku:Lab Phasemeter Moku:Lab PID Controller Moku:Lab Spectrum Analyzer Moku:Lab Time & Frequency Analyzer Moku:Lab Waveform Generator Moku:Lab Logic Analyzer/Pattern Generator
-
Moku:Pro
Moku:Pro General Moku:Pro Arbitrary Waveform Generator Moku:Pro Data Logger Moku:Pro Frequency Response Analyzer Moku:Pro Oscilloscope Moku:Pro PID Controller Moku:Pro Spectrum Analyzer Moku:Pro Waveform Generator Moku:Pro Lock-in Amplifier Moku:Pro Laser Lock Box Moku:Pro Digital Filter Box Moku:Pro FIR Filter Builder Moku:Pro Phasemeter Moku:Pro Multi-instrument Mode Moku:Pro Logic Analyzer/Pattern Generator Moku:Pro Time & Frequency Analyzer
- Python API
- MATLAB API
- Arbitrary Waveform Generator
- Data Logger
- Digital Filter Box
- FIR Filter Builder
- Frequency Response Analyzer
- Laser Lock Box
- Lock-in Amplifier
- Oscilloscope
- Phasemeter
- PID Controller
- Spectrum Analyzer
- Time & Frequency Analyzer
- Waveform Generator
- Logic Analyzer & Pattern Generator
- Multi Instrument Mode
- Moku Cloud Compile
- Moku general
- LabVIEW
Direct Ethernet connection without a router or switch
To connect your Moku:Lab to a Windows PC through Ethernet cable without a router or a switch, you will need to configure the network and assign the Moku:Lab a static IP address.
Configuring the PC network:
- In your PC go into "Settings" -> "Network & Internet" -> "Ethernet"
- Select "change network properties" and "Edit IPv4 settings"
- Configure the IPv4 setting as shown below:
Note: depending on the version of Windows operating system that you are using, you may be required to set the subnet prefix length, set this to 24.
Fixing the IP of Moku:
- Use the iPad to connect to the Moku through Wifi
- In "Select your device" menu, tap on your Moku, then tap the settings icon on the bottom left corner, this will open the "Device settings" menu
- In the "Device settings" menu, tap on Ethernet, switch on "Connect via Ethernet"
- Set "Configuration" to Manual, then set IP address to 192.168.1.167 with subnet mask 255.255.255.0
- Tap "Apply"
You should now be able to connect to your Moku through the Ethernet cable using the IP address of 192.168.1.167.