How do I adjust the sampling rate of the oscilloscope?
Written by Paul Cracknell
Updated at February 8th, 2021
-
Moku:Go
Moku:Go Arbitrary Waveform Generator Moku:Go Data Logger Moku:Go Frequency Response Analyzer Moku:Go Logic Analyzer & Pattern Generator Moku:Go Oscilloscope & Voltmeter Moku:Go PID Controller Moku:Go Spectrum Analyzer Moku:Go Waveform Generator Moku:Go Power Supplies Moku:Go Digital Filter Box Moku:Go FIR Filter Builder Moku:Go Lock-in Amplifier
- Moku:Lab
- Moku:Pro
The sampling rate of the oscilloscope is set automatically based on the timebase. The current sampling rate is displayed at the bottom of the 'Timebase' pane on the right-hand side. To get a specific sampling rate, you can adjust the timebase until the displayed sampling rate reaches the desired value. Please note if the 'precision mode' is selected, the scope oversamples to scale down the lower sampling rate. To see the alias effect, 'normal mode' is required. Please see this article for additional information.